Видео


84 Merc 50HP Idle Problems



84 Merc 50HP Runs good half and full throttle but as soon as it goes to idle it dies out, changed the plugs, cleaned with Seafoam, fresh gas, primer bulb hard before start and firm while running?

Рейтинг РейтингРейтингРейтингРейтинг
Просмотров: 10,663
Добавлено: 4 года
Длительность: 2:10
Комментарии: 9

Тэги для этого Видео:  



Найти больше видео в категории: "Autos"
Видео загрузил: tankersmelly
Показать больше видео, загруженных tankersmelly


Похожие видео:

Decarbonizing with Seafoam - 1987 Force 125 Outboard
Рейтинг Рейтинг Рейтинг Рейтинг Рейтинг
Просмотров: 36111
We bypassed the fuel tank into a strong mix of Seafoam and gas and ran the engine several times.
Mercury Outboard Tower of Power Idle Issues
Рейтинг Рейтинг Рейтинг Рейтинг Рейтинг
Просмотров: 16996
First of all, once again I normally do not work on Tower of Power motors, but in this case, it had already been to another shop a total of four...
Mercury Outboard Idle Adjustment
Рейтинг Рейтинг Рейтинг Рейтинг Рейтинг 
Просмотров: 19584
Mercury 9.9 Outboard 4 stroke carb adjustment, 2012 model year
Mercury 500 50hp Idle to 4k rpm
Рейтинг Рейтинг Рейтинг Рейтинг Рейтинг 
Просмотров: 8178
This video shows the Mercury 500 50hp outboard going from startup and idle up to 4k. The motor is running on muffs so the fuel/oil was mixed at...
84 Merc 50HP Idle Problems 2 After Carb clean
Рейтинг РейтингРейтингРейтингРейтинг
Просмотров: 5460
Took the 2 carbs apart and cleaned them with carb cleaner and blew them out with air, seems to run better, starts right from idle and keeps running :)
1985 Johnson 40hp stalling problems PLEASE HELP
Рейтинг Рейтинг Рейтинг Рейтинг Рейтинг 
Просмотров: 9918
It will run with no choke for a will and the you need Engage the choke then if you hold the choke for to long it will stall out the same way and it...
Seafoam the Green Ghost-1973 Johnson 65 hp outboard
Рейтинг Рейтинг Рейтинг Рейтинг Рейтинг 
Просмотров: 20972
Seafoaming the Green Ghost, a 1973 Johnson 65 hp Outboard.
Mercury 50Hp Thunderbolt ignition 1986
Рейтинг Рейтинг Рейтинг Рейтинг Рейтинг 
Просмотров: 48848
Mercury 50hp outboard starting from cold.
Outboard Motor Carburetor Cleaning
Рейтинг Рейтинг Рейтинг Рейтинг Рейтинг 
Просмотров: 302314
How-To-In-A-Few video on cleaning the carburetors on an outboard boat motor. Get that engine running smoothly and starting on the first crank! Both...
2005 Mercury 50 hp 2 stroke engine (clean carbs)
Рейтинг Рейтинг Рейтинг Рейтинг Рейтинг 
Просмотров: 65895
Running low RPM's at full throttel
Quad 557's
Рейтинг Рейтинг Рейтинг Рейтинг Рейтинг 
Просмотров: 69165
Because you never know when you just might need 2228 horsepower.
1975 Mercury 850 85HP Outboard
Рейтинг Рейтинг Рейтинг Рейтинг Рейтинг 
Просмотров: 26532
Demo of outboard motor for sale, a 1975 Mercury 850 Thunderbolt. Demo done on Lake Macatawa, Holland, Michigan
Sea Foam Deep Creep
Рейтинг Рейтинг Рейтинг Рейтинг Рейтинг 
Просмотров: 143894
Our new promo video for Seafoam Deep Creep
Mercury 90 running badly
Рейтинг Рейтинг Рейтинг Рейтинг Рейтинг 
Просмотров: 36812
1998 model with dodgy looking 1980s carbs with non retractable main jets. All 3 carbs cleaned with carb cleaner then blown through with compressed...
LOW RPM WOT Idle
Рейтинг Рейтинг Рейтинг Рейтинг Рейтинг
Просмотров: 14436
Here is the old merc idling. See what you think.
Spring Boat Commissioning Tips, Part II

Просмотров: 6132
BoatingLocal's Tom Richardson and Steve Lawrence of North Atlantic Marine Services walk you through more outboard commissioning steps, including...
Carb Cleaning - quick clean. sea foam evinrude 1993 spitfire intruder 150 hp looper
Рейтинг Рейтинг Рейтинг РейтингРейтинг
Просмотров: 84448
i put seafoam using a straw into the carb valves already. i also sprayed plenty on the air intake of each carb while motor was off. now im trying...
Merc 115 Dies Under Load
Рейтинг Рейтинг Рейтинг РейтингРейтинг
Просмотров: 14099
1986 Mercury 115 bogs when the throttle is put down.
Seven Marine 557 Outboard Motor
Рейтинг Рейтинг Рейтинг Рейтинг Рейтинг 
Просмотров: 259557
http://www.seven-marine.com - Seven Marine 557 outboard motor introduced with Intrepid Powerboats at the 2011 Miami International Boat Show
How to Replace an Outboard Water Pump
Рейтинг Рейтинг Рейтинг Рейтинг Рейтинг 
Просмотров: 278856
Outboard technician Phil Batista of Burr Brothers Boats in Marion, Massachusetts, shows how to install a new water pump kit on a 2004 200-hp...
Mercury 50 Hp Outboard Trigger Issue
Рейтинг Рейтинг Рейтинг Рейтинг Рейтинг 
Просмотров: 41520
Mercury 50 Hp Outboard Trigger Issue Each cylinder should only fire once per revolution, and only on one cylinder. This motor is firing on random...
How to Winterize an Outboard boat, step by step guide in HD for 96' Johnson 150 Motor
Рейтинг Рейтинг Рейтинг Рейтинг Рейтинг 
Просмотров: 109951
A detailed step by step guide to winterizing your outboard boat motor for winter storage in a below -0 environment, shown on a Johnson 2-stroke,...
Jamie Hyneman's Electric Outboard Boat Motor
Рейтинг Рейтинг Рейтинг Рейтинг Рейтинг 
Просмотров: 257793
Jamie shows Will his latest project: a hybrid electric outboard motor that he put together to replace the traditional loud gas motor of a...
Mercury motor operation walkthrough

Просмотров: 7179
Ed walks you through the operation of one of our Mercury 8hp motors
5 Mercury Outboard Motors on the Sea Marlin Fast Boat - Bali to Gili Islands
Рейтинг Рейтинг Рейтинг Рейтинг Рейтинг 
Просмотров: 1075217
This is the view from the stern of the boat. The motors are Mercury OptiMax 225's, though this boat used to run 250's. A heap of HP and weight...

Комментарии:

Автор Jerry Wiener (3 года)
First try replacing primer bulb if it's over 5 years old, make sure arrow
on it is facing skyward, if that fails to solve problem check fuel pump
operation.

Автор lomira123 (3 года)
fuel/air mixture? try adjusting that first. otherwise i had the same issue
with my '88 force outboard. Force is made by mercury. but it wouldnt stay
idling worth shit until i opened the throttle. so what i ended up doing is
adjusting the throttle so the butterfly in the carb is just cracked open. i
adjusted the tod that pushes the butterfly open. i will post a video and
show you soon. thx

Автор Dean Kessler (2 года)
carburetor needs adjusted, thats all

Автор Mark Lockwood (2 года)
CARBURATOR IS OUT OF AJUSTMENT IN THE IDLE SCREW, IT NEEDS TO BE AJUSTED
THE NEXT TIME IT DOES IT.

Автор phil cook (1 год)
confusious say...phil now has same problem and will pull and clean his
carb, 40hp only has one..hope mine fixes like yours

Автор Andrew Youngman (3 года)
FIRST check compression ... then spark .. then fuel .... but really ... if
someone PUMPS the "ball" while accelerating then you know .... also you
should NOT idle that high ... .also should not exceed 1500RPM with out
having LOAD behind the prop ----> IE" test tank" or being in the water. Uh
hem who was messing with the Base idle timing screws ... it doesn't run
GREAT you had it running at 1000 RPM+ I had recent problems and checked
compression round #1 to have 60PSI comp. changed .. fixed

Автор Roy Carpenter (2 года)
The idle jets in the carb need to be cleaned, rebuild the carbs your self,
it's not too bad

Автор BMacM65 (3 года)
Hey, my Merc 50 like yours won't throttle up past a quarter. It starts and
runs great but won't run up. Any ideas?

Автор phil cook (1 год)
confusious say...allways open vent on fuel tank...

Вставка видео:

URL 
Ссылка 

Поиск Видео

Top Видео

Top 100 >>>

Видео

Seo анализ сайта